Products

Yoke type roller bearing track rollers are mounted on a shaft or stud. They are not mounted in a housing bore but supported on a flat raceway (mating track).

1.Accommodate high radial loads
The thick-walled outer ring enables high radial loads, while reducing distortion and bending stresses.

2.Long service life
The crowned outer ring running surface is beneficial for applications where outer ring tilting relative to the track may occur or where edge stresses need to be minimized.

The yoke type track roller NA2206-2RS can support high radial loads. Due to the profiled outer surface of the outer ring, it can compensate for axial loads from minor misalignments and skews.

NA2206-2RS Support rollers bearings consists of a thick-walled outer ring with profiled outside surface profile and a needle roller and cage assembly.
seal: contact lip seal on both sides made of rubber (2RS) for high sealing effect

NA2206-2RS Support rollers bearings detail Specifications

Main Dimensions
Outer diameter(D):62mm
Tolerance for outer diameter: -0.013mm to 0 mm
Bore diameter(d):30mm
Tolerance for Bore diameter:-0.01mm to 0 mm
Width inner ring(B):20mm
Width outer ring(C): 19.8mm
Tolerance for width :-0.12mm to 0 mm
Raceway diameter inner ring(Fw):35mm
Recess diameter outer ring shoulder(D1) min.:43mm
Chamfer dimension inner ring(r1 min.):0.3mm
Chamfer dimension outer ring(r min.) :1.0mm
Dynamic load ratings(Cr):18.4KN
Static load ratings(Cor):25.5KN