Products

The sliding contact surface of this bearing is treated with a running-in lubricant. This reduces friction and wear during the running-in period. To facilitate lubrication, all bearings, with the exception of some small sizes, have an annular groove and two lubrication holes in both the inner and outer rings.

Spherical plain bearings are appropriate for bearing arrangements where alignment movements between the shaft and housing have to be accommodated, or where oscillating or recurrent tilting must be allowed at comparatively slow sliding speeds.

Steel against steel.

Double rubber sealed.

Radial spherical plain bearings support radial forces and axial loads in both directions.

GE 17 ES Radial spherical plain bearings detail Specifications

Main Dimensions
Bore diameter (d):17mm
Bore diameter Tolerance:-0.008mm to 0
Outer diameter (D): 30mm
Outer diameter Tolerance:-0.009mm to 0
Width (B): 14mm
Width Tolerance:-0.12mm to 0
Width outer ring(C):10mm
Raceway diameter inner ring(dk):25mm
Chamfer dimension bore(r1 min.):0.3mm
Chamfer dimension outer ring(r2 min.):0.3mm
Angle of tilt:α =10 °
Dynamic load ratings(Cr): 21.2KN
Static load ratings(Cor): 106KN

ABUTMENT DIMENSIONS
Abutment diameter shaft(da min.):19 mm
Abutment diameter shaft(da max.):20.7 mm
Abutment diameter housing(Da min.):23.7 mm
Abutment diameter housing(Da max.):28.3 mm
Fillet radius shaft (ra max.):0.3 mm
Fillet radius housing(rb)max.0.3 mm